Ammo Box- Dangerous Freedom over Peaceful Slavery
Instruction
Ammo Box- Dangerous Freedom over Peaceful Slavery
This was a fun, profitable, and easy-to-run project. It was run with a 20w laser at 35% power and 80 speed. It was made with a standard ammo can that can be picked up at any sporting goods store. This was a test run on one we had lying around.
A Riser Base is needed for this one. After placing the material into the machine, I had to make a few adjustments to raise the riser base a little higher for this project.
Auto measure the distance for you material
Mark your working area with the rectangle option. This file is set for the appropriate size for a standard ammo can.
Verify the correct settings for your machine. I used a 20W set at 35% and 80 speed.
Run the project, this one takes about 30 minutes so be patient
Remove the finished project from the machine and clean the work area with some rubbing alcohol to remove any residue. Also, be sure to clean the lens of the laser module with a dry tissue or cotton ball after this one. The material produces a lot of residue.