HomeTemplatesHome DecorWall Art
foxdaemonkiniata
Report
[Laser cut and engrave] Engraved circular wooden plaque with a wolf design
Project made with xTool F1 Ultra machine for Laser cut and engrave.
Project made with xTool F1 Ultra machine for Laser cut and engrave.
[Laser cut and engrave] Engraved circular wooden plaque with a wolf design
[Laser cut and engrave] Engraved circular wooden plaque with a wolf design
[Laser cut and engrave] Engraved circular wooden plaque with a wolf design
[Laser cut and engrave] Engraved circular wooden plaque with a wolf design

Fenrick The Wolf

Instruction
_1_727235.png
_1_727235
.png
Application scenario
Laser processing (300min)
Machine & module
xTool F1 Ultra
20W
Material used
3mm Brass Coin Blank
62
591

Information

      Embossed Brass Coin Using The F1 Ultra.  After the the embossing was completed, a 10 pass cleaning run was done to blow away the excess leftover materials.  Unfortunately the rest of my tools are in storage while between houses, so I haven't had the chance to do some finer polishing for the end product.

AImake Info

atomm-ai-image
Style: Low relief
[Prompt] Fenris The Wolf

Instruction

1

Step1: Embossing The Coin

Use The Applied Setting As Described Above.  These were done using a 40mm x 3mm solid brass coin blank.  Approximate Run Time Is About 4 - 5 Hours.

2

Step2: Coin Clean-Up

All this does is help dislodge and push any excess material left behind by the embossment process away.  After running this process, it is still recommended to give your project a quick rinse to dry of.  Normally I'd use a rotary tool to help make the design shine up a bit, but those are currently in storage.

Comments

Remixes

xTool Supplies Used in This Template

xTool F1 Ultra
xTool F1 Ultra

License

CC0
This work contains AI-generated content.