HomeTemplatesDecorHome DecorDesk Decor
createinspain
Report
[Laser cut and engrave] Wooden box with engraved rose design
Project made with xTool S1 machine for Laser cut and engrave.
Project made with xTool S1 machine for Laser cut and engrave.
[Laser cut and engrave] Wooden box with engraved rose design
[Laser cut and engrave] Wooden box with engraved rose design
[Laser cut and engrave] Wooden box with engraved rose design
[Laser cut and engrave] Wooden box with engraved rose design

Wooden box with engraved rose design

Instruction
Rosebox.xcs
Rosebox
.xcs
Application scenario
Laser processing (30min)
Machine & module
xTool S1
20W
Compatibles · 11
Material used
1/8"(3mm) Basswood Plywood
81
740

Information

      8cm square box with a rose engraving, suitable for holding a few chocolates or as a trinket box. The engraving is done twice, the first time does the basic design, the second time only engraves the darkest areas more.

Instruction

1

Step1: cutting and engraving

All pieces are cut and the top engraved before the pieces are moved from the bed. The engraving on the top first does a basic engrave and then will do another layer of engraving that defines it more and adds depth.

2

Step2: Construction

The lid has shallower sides. The two longer ones are glued on top of the inverted lid, on opposite sides. The two shorter pieces are glued in between.

The base is made in the same way, with the deeper sides. The rounded edge pieces are then glued inside,rounded edge up, so that about 1cm sticks up. This allows the lid to sit neatly and it does not NEED hinges. I added hinges on completion.

3

Step3: Fill with sweet treats!

Fill with whatever you like.

Comments

Remixes

xTool Supplies Used in This Template

xTool S1
xTool S1
1/8"(3mm) Basswood Plywood
1/8"(3mm) Basswood Plywood

License

CC BY-NC-SA
This work contains AI-generated content.