My piece of acrylic is 250 x 130 mm and with that it is 5mm shorter than the plywood. The difference in hight is needed to have some space for the LED strip.
- Add some glue to the back of your plywood and place it on your acrylic,make sure to align it properly
- Once your glue sets, add some glue to the bottom of the plywood and place it on one of the two small plywood pieces
- Do the same with the top of the sign and the second small plywood piece
- Wait until it sets
- Take the protection film off of your LED strip and add it to the bottom piece of plywood
- Finally add some glue to the top and the bottom of the back plate, place it between the two smaller pieces in the back of the sign and wait for it to dry
- Place your warning sign and some extra googles in front of your crafting room door or where ever you are using your laser