Report
![[Laser cut and engrave] Laser engraved cat illustration on circular glass](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/c4df478f-e5e7-4368-a8c8-ae5053f10f32?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Walle By The Fire - Cat Image on Mirror
Instruction10w_walleXmasMirror
.xcs
Show 1 more
Application scenario
Laser processing (60min)
Machine & module
xTool S1
10WAccessories
xTool S1 Honeycomb Panel
Material used
Circular Mirror
52
622
Information
[Style] Block printing
[Prompt] an orange and white maincoon kitten with less striping on the head looking at camera with big dialated eyes. it is wearing a chirstmas sweater while the background has a christmas tree and decorations next to a roaring flame at a fireplace
AImake Info
Style: Block printing
[Prompt] an orange and white maincoon kitten with less striping on the head looking at camera with big dialated eyes. it is wearing a chirstmas sweater while the background has a christmas tree and decorations next to a roaring flame at a fireplace
Instruction
1
Step1: Gather Materials and setup
Get 3mm thickness mirror, clean with windex and iso alcohol 99%, flip image horizontally in XCS, and flip mirror on shiny side facing down. I would also recommend inverting the grayscale under the adjust setting. Calibrate the machine and then enter in settings under user defined material
80% power // 200 mm/s // 1 pass // 200 lines per cm
2
Step2: Patiently Wait and enjoy =)
Of course if you have a stronger laser, it may not take as much time but for the 10w it should total to around 53 min engraving time.
After done cutting, I blew with compressed air and then cleaned with windex again. Results of these same steps are above.
Comments
Remixes
xTool Supplies Used in This Template
License
This work contains AI-generated content.