HomeTemplatesDecorHome DecorWall Art
CarvingCreatives IG
Report
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.

Deer Scene on Live Edge Board

Instruction
deerlargeboard.xcs
deerlargeboard
.xcs
Application scenario
Laser processing (70min)
Machine & module
xTool S1
20W
Material used
Live Edge Wood (Hobby Lobby)
109
548
Information
      3 majestic bucks standing in a wooded opening.
Instruction
1
Step1

Easy to run project. This was ran with a 20w laser at 70% power 200 speed. This live edge board can be found at Hobby Lobby for under 10 dollars. Finish with a few thin coats of poly for best results. 

2
Step2

Place material onto the honeycomb 

3
Step3

Auto measure the distance for you material

4
Step4

Mark your working area with the rectangle option, I marked area just inside the actual live edge

5
Step5

Verify the correct settings for your machine. I used a 20W set at 70% and 200 speed.
 

6
Step6

Run the project, this one takes a while so be patient

7
Step7

Remove the finished project from the machine and finish off with a couple of light coats of clear poly. 

Comments
Remixes
xTool Supplies Used in This Template
xTool S1
xTool S1

License

CC BY
This work contains AI-generated content.