Report
![[Laser cut and engrave] Santa Hat Earrings](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/9aeadea3-71a4-49a1-98c9-a253a052c45c?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Santa Hat Earrings
Remix
InstructionSantaHatEarringsAcrylic
.xcs
Show 1 more
Application scenario
Laser processing (30min)
Machine & module
xTool M1
10WAccessories
xTool M1 Riser Base with Honeycomb Panel
xTool M1 Air Assist Set
Material used
1/8"(3mm) Red Acrylic
92
826
Information
Simple Acrylic Earrings for the Holiday Season. Two Part design using Red and White Acrylic.
This remix is based on
Santa Hat Earrings
martinez1595Instruction
1
Step1
Use of the Honeycomb and Air assist is suggested. I did not attempt to process without either.
Ensure that the machine measures properly.
Use “Framing” to properly place the design onto the material.
Cut the red and white components.
2
Step2
Post Processing:
- Lightly sand edges to remove rough edges and burrs. Do not over-sand mating surfaces as they are cut to fit together. Avoid sanding the top and bottom surfaces.
- Wipe down surfaces with microfiber cloth to remove finger prints and clean off surfaces prior to glue.
- Glue the two hat pieces together
- after glue has cured, use Novus plastic polish 1 to clean the surface. Then use Novus 2 if any buffing is needed. Novus 2 helps remove any marks/smudges from super glue spill. Follow up again with Novus 1 to clean the surface.
- Enjoy.
Comments
