HomeTemplatesDecorHome DecorWall Art
johannpuntigam
Report
Laser cut and engrave
Project made with xTool M1 machine for Laser cut and engrave.
Project made with xTool M1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool M1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool M1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool M1 machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

´Deep Relief Krampus mirrow

Instruction
KrampusaufSpiegel.xcs
KrampusaufSpiegel
.xcs
Application scenario
Laser processing (140min)
Machine & module
xTool M1
10W
Accessories
xTool M1 Air Assist Set
Material used
Mirrow
Back of mirrow
31
287
Information
      [Style] Low relief
[Prompt] Krampus ganz, an den beinen mit hufe und am rücken eine kraxe
AImake Info
atomm-ai-image
Style: Low relief
[Prompt] Krampus ganz, an den beinen mit hufe und am rücken eine kraxe
Instruction
1
Step1: Settings Power 60%, Speed 120 mm/s, 200 Lines/cm

I used a mirror with 200x200mm.

Before I started engraving, I drew a square with 202 x 202 mm, which only serves for the correct positioning of the graphic or to move to the frame on a sheet of paper and then placed the mirror upside down on it.

 

Then I adjusted the size of the graphic to 150 x 150 mm and positioned it in the middle of the square. The Square Deleted.

Started the laser engraving process.

 

Nach dem Gravieren noch ordentlich reinigen

 

And if you like, still deposit with a color,

Will try it with LED´s in color, and frame

Comments
Remixes
xTool Supplies Used in This Template
xTool M1 Air Assist Set
xTool M1 Air Assist Set
xTool M1
xTool M1

License

CC BY
This work contains AI-generated content.