HomeTemplatesDecorSeasonal & Themes DecorHolidays Decor
BarkBeetleMichael
Report
Laser cut and engrave,Inkjet printing
Project made with xTool F1 Ultra machine for Christmas.
Laser cut and engrave,Inkjet printing
Laser cut and engrave,Inkjet printing

Santa Christmas Ornament

Instruction
JollySantaOrnament.xcs
JollySantaOrnament
.xcs
Application scenario
Laser processing、Inkjet printing
Machine & module
xTool F1 Ultra
20W
Material used
None
Black Acrylic Ornament
394
1980
Information
      Happy Santa made with the Smoke Effect in Aimake.
Instruction
1
Step1: Remove Plastic on Acrylic
Preview
Preview

Here I used a weeding tool for vinyl to help aid in the removal of the outer plastic coating. This will help save time and frustration with these little guys. I started next to the cut hole so that any scratch caused will be minimal and in a place that will likely be covered with the string in the end. 

2
Step2: Place Blank into Machine
Preview

Place the blank into your machine. I used the cutting plate on the F1 Ultra to put under mine. 

3
Step3: Watch it come to Life!

Only take a few minutes. Set up a camera or watch it happen. 

4
Step4: Add the String
Preview
Preview
Preview
Preview

Take 6-8 inches of a string or ribbon and place into the hole in the blank. Then tie the ends into a double knot. 

Comments
Remixes
xTool Supplies Used in This Template
xTool F1 Ultra
xTool F1 Ultra

License

Standard License
This work contains AI-generated content.