Wooden reversible sign with Dirty and Clean text

Select all with included SVG and size to your preference. The one we created has a diameter of 75mm. 

We use 2 passes for cutting because depending on the wood, you may hit glue pockets that might not allow the laser to cut through in one pass. 

Once your image is engraved, we give it a quick sand with 220 grit sandpaper on a sanding block to remove any overspray, be careful not to sand inside the engraving! Wipe or blow the dust youve created and move on to the magnet. 

We used a photo magnet kit we found at the dollar store, but any thin flexible magnet will do. 

Next we sized and cut our magnet by tracing a coin smaller than the wood round we just cut onto our magnet sheet, and then carefully cut that out with an Xacto knife. 

Next just peel off the adhesive side and stick it to your wood round. You can also use a dab of a good construction adhesive like PL premium for added holding strength.