VelfCreations
Report

Set of 5 Napkin Rings for Thanksgiving Dinner

Instruction
NapkinHolders.xcs
NapkinHolders
.xcs
Application scenario
Laser processing (10min)
Machine & module
xTool F1 Ultra
20W
Compatibles · 8
Material used
3mm Basswood Plywood
135
1063
Information
      Part of our 5 project Thanksgiving Video on YouTube using the xTool F1 Ultra. We created these fun napkin rings that can be engraved and cut out of 3mm Basswood
    
Instruction
1
Step1

Don't forget to watch our full video where we go over the project step by step!


Typically we like to put masking tape on wood but wanted to show what happens when you don't. There is a lot of charing around the edges. 


So we really recommend you put masking tape and remove it after the cut. If you do decide to do that you may also want to decrease the speed a bit to give the laser enough time to burn through the tape.

Comments
Remixes
xTool Supplies Used in This Template
xTool F1 Ultra
xTool F1 Ultra
3mm Basswood Plywood
3mm Basswood Plywood