Report
![[Laser cut and engrave] Snowlight decorative snowflake-themed light fixture](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/20e54466-3ecb-4732-b76f-4782280e8c37?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Snowlight decorative snowflake-themed light
Instructionsnowlight
.xcs
Application scenario
Laser processing (60min)
Machine & module
xTool M1
10W
xTool D1 Pro
20WCompatibles · 11
Material used
1/8"(3mm) Basswood Plywood
528
2787
Information
i had 2 versions for 2 size of wood
A4
and
300x300cm
Instruction
1
Step1: XCS
Preview
2 versions for two sizes of wood
one side is always mirrored
the cut-outs in the base plate have a kerf
this varies from machine to machine
2
Step2: laser
Preview
you can paint both sides
3
Step3: glue
Preview
Preview
i used the hot glue gun to glue the led strip
it dries quickly and holds well
when I glued it on, I made sure that the cable was always covered so that it didn't go over the holes
Comments
