Report
![[Laser cut and engrave,Inkjet printing] Santa Hat Frame](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/48ec7016-df73-4328-822b-ef73a30ca478.png?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Santa Hat Frame
Instructionsantahatframe
.xcs
Application scenario
Laser processing、Inkjet printing
Machine & module
xTool M1 Ultra
20WCompatibles · 11
Material used
1/8"(3mm) Basswood Plywood
24
295
Information
Cute santa hat photo frame
Instruction
1
Step1: Prepping your material
Preview
- Start out by sanding your wood very well.
- In order for your print to come out well on wood you will need to prime with the a clear coat.
- For this project. I used modge podge spray.
2
Step2: Printing & Lasering the hat
Preview
- Place your wood inside your machine
- Make sure you are in the inkjet printing setting in processing mode
- Print your image.
- Once it's done DO NOT MOVE your material
- replace the inkjet module with the laser module
- Change your module mode to lasering on flat surface
- Click Go to Process
- Once that is done, laser your other pieces as well now that the laser module is in.
- You can change out the wood to some that arent treated with the modge podge if you wish.
3
Step3: Assembly
Preview
Preview
Preview
- Glue the half frame on top of the solid piece
- Glue the frame with the hat outline on top of those two pieces
- Glue your hat in the upper left hand space where the outline of the hat is.
- Glue a magnet on the back
4
Step4: Show Off
Preview
Preview
Preview
Grab your favorite photo and slide it into the frame and throw it up on the fridge for all to see!
Comments
