stephcreated
Report

Witch Hat Photo Frame

Instruction
witchhatframe.xcs
witchhatframe
.xcs
Application scenario
Laser processing、Blade cut、Inkjet printing (30min)
Machine & module
xTool M1 Ultra
20W
Accessories
xTool LightGrip Adhesive Cutting Mat for xTool M1 (2pcs)
Material used
3mm Basswood Plywood
1
291
Information
      Create this cute magnet with wood and come photo vinyl sticker patper. 
    
Instruction
1
Step1: Prepping your material
Preview
  • Start out by sanding your wood very well.
  • In order for your print to come out well on wood you will need to prime with the a clear coat.
    • For this project. I used modge podge spray.
2
Step2: Masking your image
Preview
Preview
  • First start by bringing in the image you would like to use. 
    • you can do this by dragging the image over into XCS or just clicking the image icon in the upper left hand corner.
  • Drag the light blue object over on top of your image. 
    • Select both objects and click Create Mask on the top panel
  • Position your image the shape as desired and click done.
3
Step3: Printing your sticker
Preview
Preview
Preview
  • Place your the blue mat down on the base place and stick your vinyl sticker paper one top. 
  • Make sure you are in the inkjet printing setting in processing mode
  • Print your image.
  • Once its done DO NOT MOVE  your material
    • add your blade to the blade module
  • Change your module mode to Blade cut
    • Click Go to Process
4
Step4: Printing and lasering the witch hat
Preview
Preview
  • Place your wood inside your machine
  • Make sure you are in the inkjet printing setting in processing mode
  • Print your image.
  • Once it's done DO NOT MOVE  your material
    • replace the inkjet module with the laser module
  • Change your module mode to lasering on flat surface
    • Click Go to Process
  • Laser your other solid piece as well now that the laser module is in.
    • You can change out the wood to some scrap piece if you wish.
5
Step5: Assembly
Preview
Preview
Preview
Preview
  • Take your hat and spray it with a sealer. You can use the modge podge spray again here too.
  • Peel your vinyl sticker and place it on the half diameter piece like shown.
  • Now glue both the hat and the photo piece on to your backer piece
  • Turn your piece over and super glue your magnet to the project.
Comments
Remixes
xTool Supplies Used in This Template
xTool LightGrip Adhesive Cutting Mat for xTool M1 (2pcs)
xTool LightGrip Adhesive Cutting Mat for xTool M1 (2pcs)
xTool M1 Ultra
xTool M1 Ultra
3mm Basswood Plywood
3mm Basswood Plywood