This stand is designed to hold 2 Xbox controllers and can be personalised with custom engraving if required.

If you want to add engraving this can easily be added to the design before processing.

These are the settings used for cutting 4mm cherry plywood using the xTool D1 Pro 5w laser.

This stand is very simple to assemble but will require some wood glue for extra strength where the stands meet the base plate.

Start by assembling the tow stands, which should simply slot together without any glue as shown in the pictures above.

Next, add a small amount of glue to the 4 tabs at the bottom of each stand. Then insert the tabs into the pre cut holes in the base plate. These may be some excess glue that will need to be cleaned before it dries.