Report
![[Laser cut and engrave] 2 Layer - Kings on a Journey Remix](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/58e0a2af-1ab5-4f54-af27-6a8ce65fb48e?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
2 Layer - Kings on a Journey Remix
Remix
InstructionKingsOnAJourneyRemix
.xcs
Application scenario
Laser processing (60min)
Machine & module
xTool D1 Pro
5WCompatibles · 11
Accessories
xTool Honeycomb Working Panel Set for D1 Pro/D1
xTool Enclosure: foldable and smoke-proof cover for D1/D1 Pro and other laser engravers
Material used
1/8"(3mm) Basswood Plywood
153
788
Information
It's a bit of a challenge to glue on the two back pieces so made a one piece back and added a Star so it pops a little more.
On the silhouette we turned the star over (bottom of the cut showing) just to give it a bit more depth.
This was done on D1pro 5w - I can fit 9 on a 12x12 sheet.
This remix is based on
2layer Christmas ornament-kings on a journey
jwwood08Instruction
1
Step1
Using grid arrange the current size allows you to put 9 on a 12x12 board. I do 9 front on a board then 9 backs on a second cut. Stars stack fine between the ornaments.
See above settings my 5w uses to cut these out.
Comments
