leeleepad3
Report

Turkey Napkin Holder

Instruction
thanksgiving napkin rings.lbrn2
thanksgiving napkin rings
.lbrn2
Application scenario
Laser (5min)
Machine & module
xTool D1 Pro
10W
Material used
3mm Basswood Plywood
153
2600
Information
      We host Thanksgiving dinner at our house each year and try to make a little something for each guest. This year we are going to give each person a napkin holder. I might engrave each person's name along the right side of the hole to personalize each one.
    
Instruction
1
Step1: Settings
Preview

This is a simple cutting project, so do a material test first to find the settings to cut through whatever material you used for this project. I used 3mm basswood but I believe you could use any material you would like that you are able to cut through.

2
Step2: Personalize
Preview
Preview
Preview

Only do this step if you are going to personalize the napkin holder.

Use the text option and type out the person's name. Pick a font you would like to use. Turn the name 90 degrees so it is up and down and resize the name to fit inside the turkey. Use the curve option to curve the name along the right side of the hole. Reposition the name until you are satisfied where the name is inside the turkey.

3
Step3: Cutting
Preview

Once you figured out the settings for the material and machine that you are using go ahead and cut it out. At this point you can use the napkin holder as is or you could paint them. 

Comments
Remixes
xTool Supplies Used in This Template
xTool D1 Pro
xTool D1 Pro
3mm Basswood Plywood
3mm Basswood Plywood