HomeTemplatesDecorHome DecorShelves & Holders
Crazy Innovation
Report
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave

Lasercut Iris Box

Instruction
Iris_Box.xcs
Iris_Box
.xcs
Application scenario
Laser processing (60min)
Machine & module
xTool S1
20W
Compatibles · 9
Material used
3mm Basswood Plywood
5408
32573
Information
      This project was originally published by Lucas Fierfort on instructables.com,The plans for making this project are available for everybody to download for free.
I made a wooden dowel version, now you don't need screws to make it
Instruction
1
Step1
Preview

All the parts apart for the pieces cut out and ready to go. Having cut out all the parts follow the instructions below to assemble the gear display.

2
Step2
Preview

The lid is the rotating part at the top of the box.Stick the two lid together, ensuring alignment


 

3
Step3
Preview
Preview

1、Stick the 9mm dowel onto the base with glue

2、Place the petals on dowel and ensure petals can rotate properly

4
Step4
Preview
Preview
Preview
3 More images

1、Add the 5 15mm dowel into the lid holes through the base and the petals.

2、Flip the entire lid over, connect the 15mm dowel to the lid with glue, being careful not to stick the petals and ensuring that it can move normally

 

5
Step5
Preview
Preview
Preview

Assemble the box, and if you need, you can use glue

6
Step6
Preview

Finish！Please carefully adjust the smoothness between each component，Don't use too much force

Comments
Remixes
xTool Supplies Used in This Template
xTool S1
xTool S1
3mm Basswood Plywood
3mm Basswood Plywood

License

CC BY-NC