Report
![[Laser cut and engrave] Gaming drink coaster that will hold your dice](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/4ef2bc19-f0dd-497b-b82a-3f27485b59e9?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Gaming drink coaster that will hold your dice
InstructionDicecoaster
.xcs
Application scenario
Laser processing (60min)
Machine & module
xTool S1
40WCompatibles · 2
Material used
1/8"(3mm) Basswood Plywood
67
1482
Information
This is a 3 layered drink coaster that you are able to engrave your own design or message that reflects either your or your character while playing games.
It has a "L" shaped slot that provides you the space to keep your most used dice on hand.
The pin holes (3mm x 3mm x 9mm) provide the coaster with a more rustic charm but also provide some extra adhesion.
These coasters are made from 3mm material.
Optional variations
Making the middle layer a transparent acrylic provides a different look and when there are reasonable light source can provide an interesting spark of interest.
**A purchased design package was used in the sample images** - Please support your other designers.
Instruction
1
Step1: If you wish to make a batch
The assembly of one coaster is pretty straight forward.
However, if you are making a batch of these, and dont have large amount of clamps.
I made a template out of cardboard, any material would work here.
I also used 5 lengths of wire as the wire would not stick to the PVA easily
Poked the wire through the pin holes, which acted as guide rails for the stack of coasters.
After the layers were dry i glued in the pins to complete the coaster for gifting.
Comments
