HomeTemplatesDecorHome DecorShelves & Holders
Steve
Report
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

Martial Arts Display unit - Belts, medals and trophy display wall unit.

Instruction
martialartsdisplayunit-Final.xcs
martialartsdisplayunit-Final
.xcs
Application scenario
Laser processing (240min)
Machine & module
xTool S1
20W
Compatibles · 1
Accessories
xTool S1 Honeycomb Panel
Material used
5mm Pine Plywood
23
781
Information
      Having been doing martial arts for decades and collecting belts medals and trophies along the way I needed a solution to display my achievements rather than just a bag for life under the stairs. Its made from 5mm Ply wood, Completely personalised and strong. Without glue I was able to stand on the side and the back so it will hold up to 110kg. But mostly i wanted to test my skills and knowledge on building something different and from scratch.
Instruction
1
Step1
Preview

Ensure the 5mm Ply you use is larger than 500 x 300 mm 

All Cuts where done at 100% power 5 speed single pass

Scored Japanese writing to the side. but this can be engraved. 

Recommend for engraving using borate solution for darker engraving

Wood Glue, and Straps or large clamps.

Creativity is key here

Comments
Remixes
xTool Supplies Used in This Template
xTool S1 Honeycomb Panel
xTool S1 Honeycomb Panel
xTool S1
xTool S1

License

Standard License