Report
![[Laser cut and engrave] Let it Snow door hanger](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/897a1643-7d1e-46a5-9d53-9f73b6c01f92?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Let it Snow door hanger
InstructionLetitSnowHanger
.xcs
Application scenario
Laser processing (60min)
Machine & module
xTool M1 Ultra
20WCompatibles · 11
Material used
1/8"(3mm) Basswood Plywood
58
384
Information
Get into the holiday spirit with this let it snow door hanger!
Instruction
1
Step1: Open the file in XCS
Preview
- Open file and make any changes you wish
- I noticed when I went to put this together I doesn't look like the original deign.
- I sent back and added the scored lines to the board so that putting the design together in the end will be easier.
2
Step2: Laser
Preview
- place your material in your machine
- select your material settings
- auto measure your material
3
Step3: Paint & Assembly
Preview
Preview
Preview
- Grab your paint and glue
- I used spray paint for this project.
- Glue your pieces inside the scored lines.
Comments
