HomeTemplatesDecorHome DecorShelves & Holders
ALCustoms
Report
[Laser cut and engrave] Laser Cut Book Stand! LOW Material Use
Project made with xTool D1 machine for Laser cut and engrave.
Project made with xTool D1 machine for Laser cut and engrave.
[Laser cut and engrave] Laser Cut Book Stand! LOW Material Use
Project made with xTool D1 machine for Laser cut and engrave.
[Laser cut and engrave] Laser Cut Book Stand! LOW Material Use
Project made with xTool D1 machine for Laser cut and engrave.
[Laser cut and engrave] Laser Cut Book Stand! LOW Material Use
[Laser cut and engrave] Laser Cut Book Stand! LOW Material Use
[Laser cut and engrave] Laser Cut Book Stand! LOW Material Use
[Laser cut and engrave] Laser Cut Book Stand! LOW Material Use
[Laser cut and engrave] Laser Cut Book Stand! LOW Material Use
[Laser cut and engrave] Laser Cut Book Stand! LOW Material Use

Laser Cut Book Stand! LOW Material Use

Instruction
COMICSTAND.xcs
COMICSTAND
.xcs
Application scenario
Laser processing (8min)
Machine & module
xTool D1
10W
Compatibles · 11
Material used
1/8"(3mm) Basswood Plywood
55
939

Information

      If you have a use for displaying books as I do, then this community-shared book stand project is all yours! These display either 1 Chapter Book, 10 Comic Books, 4 TPB Comics, 2 Graded Comics. Ive tried all and it withstands the pressure and size of all! Also Customize the face to your brand or novel display names!

Instruction

1

Step1: Organize and Glue

Laser Cut Book Stand! LOW Material Use instruction: step 1 - Organize and Glue
Preview

This is the time to customize your face piece, or just not have one at all!

Cut and gather your pieces together, which should include the 5 piece shown above! (Including your face piece glued together)

2

Step2: Gluing Notches/ Constructing

Laser Cut Book Stand! LOW Material Use instruction: step 2 - Gluing Notches/ Constructing
Preview
Laser Cut Book Stand! LOW Material Use instruction: step 2 - Gluing Notches/ Constructing
Preview
Laser Cut Book Stand! LOW Material Use instruction: step 2 - Gluing Notches/ Constructing
Preview

Glue the Notches and insert the face piece on the Big Stand Pieces.

Glue the Cuts on the back face and insert the skinny Back Supports.

After this youre all set!

Wait about 30 minutes for glue to dry.

Comments

Remixes

xTool Supplies Used in This Template

xTool D1
xTool D1
1/8"(3mm) Basswood Plywood
1/8"(3mm) Basswood Plywood

License

CC0