HomeTemplatesDecorHome DecorShelves & Holders
AS RebelDesign
Report
Laser cut and engrave
Project made with xTool D1 Pro machine for Laser cut and engrave.

Battery Pack Holder BoschPro/Makita

Instruction
BoschPro18vBatPac.xcs
BoschPro18vBatPac
.xcs
Application scenario
Laser processing (25min)
Machine & module
xTool D1 Pro
10W
Material used
2mm MDF DIN A3
60
457
Information
      Battery Pack Holder to store BoschPro/Makita 18v Packs. Battery pack holders that you can buy are usually expensive. I was looking for a cheap solution and here it is.
Instruction
1
Step1: Cut out


Place the long side of the material on the x axis of the laser, adjust the focus and place the laser in the upper left corner of the material with approx. 5mm distance to the edges. Before you start, check whether you are using relative or absolute settings. Cut it out.

2
Step2: Assembly
Preview
Preview
Glue the 4 spacers between the two panels with wood glue or superglue. Let it dry.
3
Step3: Mounting
Preview
Use the 2 holes to screw on the holder, insert the battery packs. Finished ;-)
Comments
Remixes
xTool Supplies Used in This Template
xTool D1 Pro
xTool D1 Pro

License

CC BY-NC-SA