Drew's Den
Report

Pupkin Light

Instruction
pumpkinlight.xcs
pumpkinlight
.xcs
Application scenario
Laser processing (20min)
Machine & module
xTool S1
40W
Compatibles · 9
Material used
3mm Basswood Plywood
15
435
Information
      This is a small pumpkin light that I made. Just make sure not to use a real candle. 130/312
    
Instruction
1
Step1: Design
Preview
Preview
Preview
Preview

For this, I made a small template with all the sides of the box. Then, I will insert the pumpkin, ungroup it, and select only the inside to set it for cutting. Finally, I will place it on one of the sides and subtract it to create the pumpkin light shape.

2
Step2: Matrial
Preview

For this, I used Xtool basswood and would recommend it, or maybe an orange acrylic if you really want it to look like a pumpkin.

3
Step3: Laser Time
Preview

Now it's time to laser your project. Make sure your settings match your machine and material—this is an S1 40. Don't forget to wear your laser safety glasses!

4
Step4: Assembly
Preview

Now you will need to glue the pieces together, and you should be done. Just make sure the smaller pieces are on opposite sides, like in the photo above.

5
Step5: Your done
Preview

Good news! You're done with your box—great job! Now you're a little closer to Halloween!

Comments
Remixes
xTool Supplies Used in This Template
xTool S1
xTool S1
3mm Basswood Plywood
3mm Basswood Plywood