HomeTemplatesDecorHome DecorShelves & Holders
Sugarwalker
Report
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

Sales Display

Instruction
Filz.xcs
Filz
.xcs
Application scenario
Laser (60min)
Machine & module
xTool S1
40W
Material used
6mm Basswood Plywood
felt
6mm Plywood
0.6 mm Felt
6mm Birch Plywood
3
273
Information
      I needed a small Display for selling my DIY products at a gasstation.
There for i took an 6 mm plywood and cuted an d engraved it wit the Xtool S1 40W. For decoration i cutted also an piece of felt and glued it on the plywood. A very easy, cheap and fast way to presentate my products.
Instruction
1
Step1: Cutting the Plywood

For the felt i needed a bit, to find the perfect setting. If the felt is in an lighter colour, you should reduce the speed. 

2
Step2: Engraving the Plywood

I want a darkbrown colour for the engraving, after an engrave test i choose this settings.

The first try was an sucsses.

Comments
Remixes
xTool Supplies Used in This Template
xTool S1
xTool S1
6mm Basswood Plywood
6mm Basswood Plywood

License

Standard License