Report
![[Laser cut and engrave] TV remote control holder](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/48912047-9868-4253-a479-02fdc803f81d?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
TV remote control holder
InstructionTVremoteholder
.xcs
Application scenario
Laser processing (35min)
Machine & module
xTool D1 Pro
5WMaterial used
4mm MDF
185
1436
Information
Remote controls are easy to misplace and expensive to replace if broken so having a place to store and organise them can be very useful. This organiser can hold 3 remotes of different sizes and the angled design makes it easy to access even small remotes in the front section.
Instruction
1
Step1: Design
Preview
The design of the remote holder is simple yet functional and consists of 2 side pieces featuring remote control engraving, a bottom piece, and 4 inside pieces to divide the space into 3 sections.
2
Step2: Cutting settings
These are the settings used to cut 4mm MDF using the xTool D1 Pro 5w laser.
Most 4mm materials should cut with these settings but they will need to be adjusted for use with other laser machines.
3
Step3: Score and engrave settings
Preview
The remote outlines on the sides are scored while some of the buttons are engraved to stand out and add contrast.
4
Step4: Assembly
Preview
This organiser is simple to assemble and all parts should slot together tight enough not to need any glue, although glue can be used to add extra strength if needed.
Comments
