Step 1) First thing for these curtains to be created is to make a circle with the insert button, I sized it to be 5.5" in Diameter, Then I copied and pasted the circle to create a second one and sized it a bit smaller at 4" diameter.

Step 2) I then placed it in the smaller circle inside the larger circle and wanted them to be completely center so I used the align tool and selected horizontal and vertical. I then used an item from the shape list and selected the heart, I then used the array to make a circle shaped array of many hearts to make a circle. Once again I copied and pasted them to create 2 sets after which I used the align tool once again to have everything lined up in the center.

Step 3) In this step a rectangle was created along with small circles to be attached at either end of the rectangle, this was done with the unite tool, once this was complete they too were copied and pasted as 2 of them were also needed.

Step 4) this step all the settings for the laser machine took place, there is cutting and scoring for this project

Step 5) This step is installing the curtain holders, these happen to be going in our master bedroom ensuite, the nice thing about these is the can be removed with a simple one slide of the cross bar to close the curtains for privacy.