Glow in the Dark Ghost Earrings

Instructions are also included in a PDF Format. 

Note that this item is made with translucent material and as such, the cuts on other machines may not be as clean or even possible. This item is suggested to be made with a P2.

Be sure to remove the plastic coating on the Arylic before cutting. To help with hazing on the acrylic, I coated the surface in dish soap. Once completed, I rinced it off easily. Use the settings above to cut the Ghost Earrings out from your material.

I like to use something from Amazon called Earring Hooks with Pinch Bail Clasps. It makes putting hook earrings together so much easier on your hands and is highly recommended for people with arthritis or joint issues in their hands. You basically put the Pinch Bail into one side of the earring in the hole at the top and “pinch” it shut so that the other side of the clasp falls into the opposite sides hole. Using your jewelry pliers, give it a slight squeeze to firmly set the clasp.

If using jump rings and hooks, insert the jump ring into the hole at the top of the earring and then add on a hook. Make sure the hook is facing the back of the earring. Using your jewelry pliers, gently squeeze the jump ring together until the tips meet. Be sure the jump ring is completely closed to prevent the hook from falling off.