LastGuitar420
Report

Wallart of Feathers

Instruction
WallArt 3.svg
WallArt 3
.svg
Application scenario
Laser (250min)
Machine & module
xTool D1 Pro
10W
Material used
1/8"(3mm) Birch Plywood
55
568

Information

      A frame with feathers, colored with bronze paint and sealed with varnish. 15x30 inches
    

Instruction

1

Step1

Put the design on the Creative Space with the Laser Extension Kit because the size of the cut

it's of 15x30 inches. 

I don't remember to much the settings but i think I used my base settings that I use everytime

90 or 100 power, 2/ms speed and 2 or 3 passes to be sure that it's a clean cut using the Air Assist or it will burn your cut and will became really messy and dirty. 

 

Then I like to paint with Gold Bronze spray because I'm not good with the brush so I use spray

2 or 3 passes and then finish with glossy varnish 2 passes to seal the plywood.

 

Comments

Remixes

xTool Supplies Used in This Template

xTool D1 Pro
xTool D1 Pro
1/8"(3mm) Birch Plywood
1/8"(3mm) Birch Plywood