Report
![[Laser cut and engrave] You Should Leave Door Hanger](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/8f7a4683-9629-46a6-a5dc-ed28f428e80e?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
You Should Leave Door Hanger
InstructionYouShouldLeaveHalloweenHanger
.xcs
Application scenario
Laser processing (60min)
Machine & module
xTool M1
10WCompatibles · 11
Material used
1/8"(3mm) Basswood Plywood
78
670
Information
Scare off your guest or not wanted vistors with this door hanger
Instruction
1
Step1: Open in XCS and laser prep
Preview
- RED = CUT
- BLUE = SCORE
The font used is an XTOOL install font it has drip in and some of them will get cut off during the cut process. You can change the font if you would like.
I like to go back back and fill those spaces in with red paint
2
Step2: Paint & Assembly
Preview
Preview
Preview
Incase you missed it at the top:
The font used is an XTOOL install font it has drip in and some of them will get cut off during the cut process. You can change the font if you would like.
I like to go back back and fill those spaces in with red paint
- Paint your pieces and glue within the score lines.
- I glued the dripping blood over the welcome letters it does not contain any score lines for glueing
- The knife does not contain any scored lines for glueing. I glued it to the right but looking back I think I was meant to glue it on the left side of the face when designing as there is a big space there.
Comments
