Create 1 circle of 800 x 800 mm and 4 circles of 1.4 mm each

We are going to place the small circles in 4 points, these will serve to anchor the wire so that our pearls are aligned around our medallion.

First we cut the piece of wood, then we paint with gold acrylic spray paint and proceed to engrave! 

After engraving both sides, we insert the wire into the top hole and insert the beads and so on. When we finish, we hang our cord and place the bow and the bells, and lastly we will hang the tassel.

to cut use xTool D1 Pro/D1 Air Assist Set and honeycomb

***If the honeycomb had to be placed 3 passes for a perfect cut, with the use of the honeycomb it is reduced by 1 pass
 

I increased the lines for a sharper engraving!