Halloween Coaster
Instruction
First I'll take the measurement of the coaster
this has the advantage that you can use the frame as a guideline
create a rectangle in XCS
you can enter the dimensions on the side
on the site you can find the templates
and xtool has a lot of templates on the theme of halloween
find the right ones and put everything into the rectangle
i would like the lower symbols to all be at the same height
this can be achieved by marking them all and also the rectangle
on the side select allign bottom
with the M1 you can place it well with the camera function
it is important to place the coaster high up in the middle so that you have the greatest accuracy
here it is also advantageous if you use the framing function and see how far the laser is lasered
Attention
do not forget to remove the frame before lasering