Report
![[Laser cut and engrave] Pencil bag charm](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/0b64b5cb-e627-4e53-8af7-66f727030350?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Pencil bag charm
InstructionPencil bag charm
.xcs
Application scenario
Laser (15min)
Machine & module
xTool M1
10WCompatibles · 9
Material used
3mm Pine Plywood
52
636
Information
A cute charm for your little one - or even good for a teacher-appreciation gift. (I added a tiny name with engraving settings - in case you want to make it bigger, you can engrave a name to it to personalize.
Instruction
1
Step1: Score and cut the design
Preview
Preview
With using the attached design file, use a small piece of plywood, and cut out the design.
2
Step2: Painting
Preview
Preview
Preview
Start painting your charm. I used markers, maybe it would be better to use some fine-point ones for this design.
Start with the contour lines, and let them dry, then you can add the other colors.
3
Step3: Varnish
Preview
Preview
Preview
Once it is completely dried, use varnish to strengthen your charm, and make a glossy finish on that. I applied it with paintbrush, but you can use spray too.
Make sure that you add varnish to both front and back, and also the sides.
4
Step4: Add accessory elements
Preview
Preview
If it died, you can add the bag charm accessories.
Feel free to adjust this design, & share your creation too.
Comments