HomeTemplatesGiftsGifts for Teacher
Grab a Coffee
Report
Laser cut and engrave
Project made with xTool M1 machine for Back to School.
Project made with xTool M1 machine for Back to School.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

Pencil bag charm

Instruction
Pencil bag charm.xcs
Pencil bag charm
.xcs
Application scenario
Laser (15min)
Machine & module
xTool M1
10W
Compatibles · 8
Material used
3mm Pine Plywood
44
608
Information
      A cute charm for your little one - or even good for a teacher-appreciation gift. (I added a tiny name with engraving settings - in case you want to make it bigger, you can engrave a name to it to personalize.
Instruction
1
Step1: Score and cut the design
Preview
Preview

With using the attached design file, use a small piece of plywood, and cut out the design.

2
Step2: Painting
Preview
Preview
Preview

Start painting your charm. I used markers, maybe it would be better to use some fine-point ones for this design.

Start with the contour lines, and let them dry, then you can add the other colors.

3
Step3: Varnish
Preview
Preview
Preview

Once it is completely dried, use varnish to strengthen your charm, and make a glossy finish on that. I applied it with paintbrush, but you can use spray too.

Make sure that you add varnish to both front and back, and also the sides.

4
Step4: Add accessory elements
Preview
Preview

If it died, you can add the bag charm accessories.

Feel free to adjust this design, & share your creation too.

Comments
Remixes
xTool Supplies Used in This Template
xTool M1
xTool M1
3mm Pine Plywood
3mm Pine Plywood

License

CC BY