Report
Christmas Pin "Noel" Star
InstructionNoel-Star-Addon
.xcs
Application scenario
Laser (10min)
Machine & module
xTool M1
10WCompatibles · 9
Material used
3mm Basswood Plywood
59
722
Information
For Christmas lovers this is a nice gift for bags, backpacks or canvas to have. Just a small Addon with the the french word as this sounds very lovely.
Instruction
1
Step1: Settings
Preview
Preview
This Design is created to Engrave the Green part to have the Star and Word Noel as the bright wood to stand out. So it's kinda a negative engraving.
Red = Cut
2
Step2: Assembly
Preview
Preview
Preview
Preview
- Clean the front side with a brush and some water and let dry
- Get your pin blanks and only add a smal glue dot (I'm using E6000plus)
- Press on backside in the middle, if you made the pin bigger you might need to use 2 pins instead of only one.
- Let dry completely before attaching to anything
3
Step3: Finished Look
Preview
Preview
Preview
Preview
Just Add it to anything you like. I have it on my little purse for crafting stuff.
I hope you like the Design and have fun using it for your personal projects! ~Anzy
Comments
Remixes
xTool Supplies Used in This Template