Switch on the machine, open xTool Creative Space on your computer, drag in the required xcs file, select Combined Processing, check the modes and parameters of each layer, and then proceed with the processing after confirming.

Place the knife strip floor on the base plate again and fix the wooden board on the knife strip floor. You can use the beautiful paper to fix the wooden board to prevent it from shifting during the machining process. Install the inkjet module, mark the machining area, remove the inkjet cover for machining. The software will prompt the next step, remove the inkjet module and install the 10W laser module, do not move the position of the board, the laser cutting can be turned on the air pump to effectively alleviate the board burnt yellow staining.

Knife cut mode processing, knife cut soft magnetic sheet.

Spread the glue evenly over the surface of the board and shine a violet light on it. The glue will solidify quickly, and you can also add some glitter or gold foil before shining the light on it.

When the work is finished, paste the soft magnetic sheet on the back and the fridge sticker is finished.