Report
![[Laser cut and engrave] T-Rex Snacks Make Me Smart](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/69945a73-494f-4dc5-9349-3f8e32fa3700?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
T-Rex Snacks Make Me Smart
InstructionT-Rex Snacks Make Me Smart S1
.xcs
Show 1 more
Application scenario
Laser (10min)
Machine & module
xTool F1 Ultra
20WMaterial used
Bamboo
45
648
Information
Back to School Project for a Snack Container. Snacks are a important part being able to stay focused and absorb more information at school.
Instruction
1
Step1: Decide What to Put it on!
Preview
With all the options at your finger tips, now is the time to decide what to Engrave!
I found a cool Tupperware container with a bamboo lid!
2
Step2: Set Up Material Settings
Preview
It's likely that you will be using this file for another machine than what's listed. I included my settings for both F1 Ultra and S140w.
3
Step3: Load Material and Run the Job!
Preview
Place your material onto the bed of the machine. Align everything. Double Check and then Engrave!
4
Step4: Clean Up
Preview
Now that the engraving is finished, it's time for clean up.
I either use alcohol wipes or sand paper. Bamboo has more sap and is harder to clean. I would just opt for some Dawn Power Wash or sand paper.
Paint and seal as desired.
5
Step5: All Finished
Preview
Preview
Time to enjoy your creation.
Comments
