Report
![[Laser cut and engrave] Santa Gnome on a swing ornament](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/107088a4-508a-460f-8e93-dc7054d4ed74?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Santa Gnome on a swing ornament
Gnome swing
.xcs
Application scenario
Laser (30min)
Machine & module
xTool M1 Ultra
20WCompatibles · 11
Material used
1/8"(3mm) Basswood Plywood
3mm Basswood Plywood
10
815
Information
Made a Santa Gnome on a swing. Used the M1 Ultra to make the print, then cut it out with the P2. Attached the bottom part to the feet of the Gnome and attached the rope through the holes on both sides of the bottom part. Then glued the rope on the back side of the hands and slit the rope through the holes on the smaller piece of wood and made knots on the bottom part and the top part, so the wood would not slide. Then took both ends of the rope and made a knot,
Comments
