Summer vibes fan

• To get the shapes I needed for my fan with the help of my printer, I scanned the parts of the fan, entered the images into the program and trace image

For the images I used to mark, I downloaded 2 vectors, one of a leaf and one of a hibiscus... I did not use engraving because it was very dark and did not look good.

 from the widest piece I cut 2, and from the internal pieces I cut 12

1. With jewelry wire, we joined our parts and to close, with the help of a tweezer, we tied a knot on both sides.
2. We open the fan and put tape to prevent it from closing, and we take the measurements for the fabric.
3. We cut the fabric, and we are going to iron our textile vinyl design that we cut with the cameo previously
4. Then we put glue on each of the pieces and place the fabric stretched.