Turn on the machine and install the laser module.

Bass plywood is put into the machine,Use masking tape to secure, click on the auto measure to ranging, mark the processing area, Check the parameters, and prepare for Laser process.

Glue the bottom plate and the rain shield.

Take out the cut parts and assemble them in the order shown in the picture.

Put the Self-adhesive Vinyl on the adhesive board, import it into xcs, and start cutting.

Apply Self-adhesive Vinyl to the cat food bowl.

Stick the cardboard on the adhesive board, stick the four sides of the gold foil paper on the cardboard, and start embossing and cutting with a fine knife.

1. Stick double-sided tape on three sides of the yellow card paper
2. Stick the top of the red card paper along the edge of the yellow card paper
3. Bend the red card paper and stick the bottom along the bottom of the yellow card paper
4. Rotate the paper once and stick it

Completed production!