![[Laser cut and engrave] Back to school -Stamping film hot press pen holder](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/40d65ff6-5f46-4950-bdcb-415a983cfa5e?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Back to school -Stamping film hot press pen holder
Instruction
Information
The school season is just around the corner, make a special pencil holder with your child! Have fun in creating it!
Instruction
Step1: Prepare for processing
Switch on the machine, open xTool Creative Space on the computer, drag in the required xcs file, mirror the prepared text content, confirm the parameters and prepare for processing.
Step2: Cutting Paper
Installation of passive knife head and install fine cutting knife, will be used to the hot stamping film in order to put into the machine, the processing range of calibration, adjust the parameters for fine cutting knife cutting. Paper cutting and processing of the base plate needs to be padded blue sticky board fixed paper, if the sticky board is not very strong adhesive can be used to paste the edge of the paper edge fixed.
Step3: Heat press printing
Remove the excess unwanted film and place it in the position you need to emboss. Use H1 machine (or heat press machine can be) wait for the machine preheating is completed, when the green light is on, it means that the preheating is complete. (Temperature: 170℃ Time: 10 seconds)
Step4: Hot pressing completed
When the countdown is complete, lift the machine handle up and move the hot stamping machine out of the way, being careful of hot hands, wait for the hot stamping film to cool down and then gently remove the transparent film layer.
Step5: Notes
- Using M1ultra knife to cut the stamping film need to be in advance of the text content mirror image.
- you need to wait for cooling before you can uncover the film.
