• Start by creating a 11.5" x 11.5" diameter
• Find some leave graphic you would to use
  • you can trace the image if you need to.
  • I used a free image and brought it into xcs
• create your text and place how you would like it.
• Create the letter “F” and size it on top of the first leaf
  • Right click copy and paste
  • change the copied one to “A”
  • do the same for both "L"

• Check your settings and make sure the correct material is set
• Grab your material and auto measure it once you get it into the laser

Paint

• For this project I used a spray stain on the backer board
• Spray paint for the leaves and text

Glue

• I would glue your leaves down on the board first and then place and glue your FALL letters after