HomeTemplatesDecorHome DecorShelves & Holders
stephcreated
Report
[Laser cut and engrave] Give Thanks Napkin Holder
Project made with xTool M1 machine for Thanksgiving.
[Laser cut and engrave] Give Thanks Napkin Holder
[Laser cut and engrave] Give Thanks Napkin Holder

Give Thanks Napkin Holder

Instruction
GiveThanksNapkinHolder.xcs
GiveThanksNapkinHolder
.xcs
Application scenario
Laser (15min)
Machine & module
xTool M1
10W
Compatibles · 11
Material used
1/8"(3mm) Basswood Plywood
3mm Basswood Plywood
23
562

Information

      Spruce up your Thanksgiving table with these give thanks napkin holders

Instruction

1

Step1: The Design

Give Thanks Napkin Holder instruction: step 1 - The Design
Preview
Give Thanks Napkin Holder instruction: step 1 - The Design
Preview
Give Thanks Napkin Holder instruction: step 1 - The Design
Preview
  • start by creating a small circle
  • create another smaller circle inside of that one
  • Create text for this project I used “give thanks”
  • arch the text so its arching with outter circle
    • to arch text click on the text and click and drag the arching symbol to the right of the text
  • Once you have the text arched drag the text over the circle so it is overlapping slightly
    • you might have to play with the arch again if not all the characters are overlapping.
  • set both larger circle and the text and click “unite” on the right side panel
2

Step2: Laser

Give Thanks Napkin Holder instruction: step 2 - Laser
Preview
  • Make sure all objects are set to “cut”
  • Auto measure your material
3

Step3: Notes

Give Thanks Napkin Holder instruction: step 3 - Notes
Preview
  • This can be painted, stained or left bare.
  • I think I nice stain and varnish will make it look great!
  • You can also double cut this to make it extra strong and glue the two pieces together. 
Comments

Remixes

xTool Supplies Used in This Template

xTool M1
xTool M1
1/8"(3mm) Basswood Plywood
1/8"(3mm) Basswood Plywood
3mm Basswood Plywood
3mm Basswood Plywood

License

CC BY-NC