HomeTemplatesTools & Special MaterialsJigs
bahenry1999
Report
Laser cut and engrave
Project made with xTool M1 machine for Laser cut and engrave.
Project made with xTool M1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool M1 machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

Paint Stand

Instruction
Paint Stands.xcs
Paint Stands
.xcs
Application scenario
Laser (6min)
Machine & module
xTool M1
10W
Compatibles · 9
Material used
3mm Basswood Plywood
63
735
Information
      I made these out of scrap wood.  Often, I've made a project on the M1 and need to lift the material as I paint edging.  These are customizable sizing.  There's 1/2 inch spacing of notches to let you set the size to what you need.  
These are sized to be made out of 3mm stock.  The file has the top-notched and bottom-notched sizes.  and the working parts over to the side if you need to adjust notch sizing for you stock material.
Instruction
1
Step1: Load file into the machine

Arrange the cut files over your leftover scraps and cut as many as needed.

2
Step2: Use stands

The stands can be arranged in any configuration needed to support your project material.  stand pieces can be chained in as many as needed.

Hope this is a useful tool for you.

Comments
Remixes
xTool Supplies Used in This Template
xTool M1
xTool M1
3mm Basswood Plywood
3mm Basswood Plywood

License

CC BY-NC