Report
![[Laser cut and engrave] Color marking on Stainless Army Tag with Ultra](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/3a3e9ae2-73e5-4dd9-8f7e-e8280dad56a2?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Color marking on Stainless Army Tag with Ultra
InstructionF1U Color Rock Festival
.xcs
Application scenario
Laser (6min)
Machine & module
xTool F1 Ultra
20WCompatibles · 4
Material used
.png?x-oss-process=image/resize,m_mfit,w_32,h_32,limit_0/interlace,1/format,webp/auto-orient,1)
Round Tags-15*15mm-Silver
Silver Stainless Steel Military Tag
313
2791
Information
The project was a test on the colors created from the Ultra with different speed and power settings on each layers.
Instruction
1
Step1: Open the xcs file
Preview
Preview
The following file has been layered with separate layers with different power and speed. On the bottom left hand you may click on the color botton to tweak your own settings if you wish.
2
Step2: Recheck the settings
Preview
Place the stainless steel tag on the base click on refresh button so the camera will take a shot. Click on the ruler so it can be auto measure the thickness of the tag.
Place the file on top of the tag position of your choice and hit framing to make sure the image is within the stainless steel tag. Finally stop the framing button and hit the green bar to start engraving.
3
Step3: Layer by Layer
Preview
Preview
Preview
The process was done layer by layer.. until finished.
Comments
