Report
![[Laser cut and engrave] Reusable Birthday Sign](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/0709995f-be1a-4cfb-bc65-92c1a0fec46e?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Reusable Birthday Sign
Instruction BirthdaySign
.xcs
Application scenario
Laser (60min)
Machine & module
xTool M1
10WCompatibles · 11
Material used
1/8"(3mm) Basswood Plywood
3mm Basswood Plywood
90
1167
Information
Want to celebrate each member of the family's birthday? This nice countertop Birthday is perfect!
Instruction
1
Step1: Open File in XCS
Preview
- Open the file in XCS and prep to send to laser
- Make you auto measure you material and all settings are correct.
- RED= CUT
- PURPLE= SCORE
2
Step2: Notes: DRY ERASE OR CHALKBOARD SPRAY PAINT
Preview
- You have two options you can use dry erase board or chalkboard spray paint
For this project I used sublimation white board that I purchased from Amazon
- If you go this route, there is thin film on top of the board make sure you remove that before cutting.
- my settings for this was 100/6/4
3
Step3: Paint & Assembly
Preview
Preview
Preview
Paint your objects and glue them as shown.
4
Step4: Base
Preview
I always save my base for last so I have the exact dimesions and it fits snuggly. I recommend doing the same for your project, cut the base last and measure as shown with your digital calipers and use those dimensions for your slot.
- Measure the length and the thickness
Comments
