![[Laser cut and engrave] Layered Leaf Wall Art](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/208a6871-f5a3-4d7f-8d0c-a68009d05b47?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Layered Leaf Wall Art
Instruction
Information
The layered design creates a depth effect, as if one is peering through trees into a forest. This project serves as an excellent introduction for beginners. It can be crafted using only a single sheet of 12x12x1/8 inch basswood plywood.
Instruction
Step1: Resize and Customize
Before you transfer the file to your laser, you may need to adjust the dimensions of the design to fit your workpiece. Simply select ach part and use the H and W properties to adjust.
Step2: Separate the cut out parts
After the job is complete on the laser, separate the parts from the 3mm basswood material. You may need to use a knife to cut the wood all the way through if there are fibers that remain connected.
Step3: Add a stain to the desired parts
Next, use a stain or paint to add color to the design. I chose to stain the top layer. Since the base layer has engravings, it may not work well with a dark stain like i used.
Step4: Apply Glue
Next, apply a thin layer of glue to the back of the top layer. Don't use much because any excess will result in squeeze out. If you get glue squeezing out the sides, just use a damp paper towel or cloth to wipe away the glue while it is still wet.
Step5: Let Glue Set
Using a weight to apply even pressure to the parts, let the glue cure over at least one hour.
