HomeTemplatesDecorSeasonal & Themes DecorHolidays Decor
scrapbookmemories
Report
Laser cut and engrave
Project made with xTool M1 machine for Winter.
Project made with xTool M1 machine for Winter.
Laser cut and engrave
Project made with xTool M1 machine for Winter.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

Snow deer and trees Winter decor for D1 Pro and M1.

Instruction
M1 Snow deer cut.xcs
M1 Snow deer cut
.xcs
Application scenario
Laser (60min)
Machine & module
xTool M1
10W
Compatibles · 8
Material used
3mm Birch Plywood
201
2764
Information
      Cut, paint and assemble,  3mm birch plywood used.Christmas decor.
Note: The slots on the bottom piece is made for 3mm plywood (Not applicable or fit for 5/6mm)
Instruction
1
Step1: Prepare 3mm plywood
Preview
Preview
Preview

Measure 345x290mm to be placed on the base of M1 preferably on top of honeycomb and air-assist used. Works with D1 Pro 20w setting for 20w 60% 10mm/s 1pass.

2
Step2: Spray paint White base
Preview
Preview
Preview
5 More images

Use any acrylic spray paint on the cut outs. And a slight of green on the edges. Finally top up with glitters(Decoart Twinkle writer)

3
Step3: Slot all the pieces to its respected places
Preview
Preview
Preview

Glue the bottom pieces(2 piece base). Allow 24 hours to dry.

Comments
Remixes
xTool Supplies Used in This Template
xTool M1
xTool M1
3mm Birch Plywood
3mm Birch Plywood

License

CC BY-NC