Report
![[Laser cut and engrave] Acrylic Flower or Heart Ring.](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/6c1f319e-35a1-4f5e-9dd6-c541ddfaecfb?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
![[Laser cut and engrave] Acrylic Flower or Heart Ring.](data:image/gif;base64,R0lGODlhAQABAAAAACH5BAEKAAEALAAAAAABAAEAAAICTAEAOw==)
Acrylic Flower or Heart Ring.
Instructionflower-ring-heart-ring
.xcs
Application scenario
Laser (30min)
Machine & module
xTool P2
55WMaterial used
1/8"(3mm) Black Acrylic
3mm Black Opaque Glossy Acrylic
16
825
Information
Make an acrylic ring for your daughter or your loved one. This was made with the Xtool P2, but you can also make this with a diode laser. Then make sure you have acrylic that a diode laser can cut.
Instruction
1
Step1: Cut out the pieces from the xcs file
Preview
Preview
Step 1
First cut out the ring. Measure the tab of the ring with a caliper. Then make a square in the flower or heart with the size you measured. This is so that the flower or heart can be attached tightly to the ring.
In the flower or heart design, the square is green, so adjust it to your size. This way you can cut the ring larger or smaller.
After adjusting the flower or heart you can cut it out.
2
Step2: Assemble the flower or heart ring.
- First, take a dab of glue on a piece of paper .
- Use the applicator brush to spread glue around the tab of the ring.
- Then take the heart or flower and place it over the tap, pressing it firmly.
- Then take the little heart and coat the bottom with glue. It is a very small heart, so you can use tweezers to place it neatly in the center of the flower or heart.
Comments
