HomeTemplatesFashion & WearablesAccessories
scrapbookmemories
Report
Laser cut and engrave
Project made with xTool P2 machine for Laser cut and engrave.
Project made with xTool P2 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool P2 machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

How to cut tiger keychain with P2

Instruction
P2Tigerkeychainacrylic.xcs
P2Tigerkeychainacrylic
.xcs
Application scenario
Laser processing (15min)
Machine & module
xTool P2
55W
Material used
3mm acrylic
58
689
Information
      The original tiger image was downloaded from creative fabrica. Its a simple project great fun for beginners.
Instruction
1
Step1: Place 3mm clear acrylic
Preview
Preview

Before putting the acrylic sheet remove the protective sticker then putting the acrylic on top of slates. Take a shot.

2
Step2
Preview

The engrave layer 15% and 250mm/s and cutting layer set at  100% 20mm/s.

3
Step3: Engrave layer and cut
Preview

It will process as engrave layer 1st run before it will proceed  to cut. The total process is about 15min.

Comments
Remixes
xTool Supplies Used in This Template
xTool P2
xTool P2

License

Standard License